Dolgellau, Gwynedd
Draught Proofing & Restoration in Dolgellau
Routed-in brush pile, new cords and rebalanced weights turn a rattling original sash into something that seals and glides.
We treat draught proofing & restoration in Dolgellau as joinery rather than a product line. That means real sections, real ironmongery and a finish specified for the exposure the building actually gets.
What is included
- Micro-porous finishes that let the timber breathe rather than trapping moisture behind a hard film.
- Factory-finished in controlled conditions — three coats minimum, fully cured before delivery.
- End-grain sealed at every cut before assembly — the single detail that decides whether joinery rots.
- Micro-porous finishes that let the timber breathe rather than trapping moisture behind a hard film.
Most draught proofing enquiries we take from Dolgellau start with a photograph and a rough measurement. That is enough for an indicative figure — the survey firms it up.
We survey across Gwynedd at no charge and with no obligation. You get a fixed written price, a lead time and a drawing before anything is ordered.
Draught Proofing in Dolgellau
Free measured survey, fixed written price.
Indicative price now
Four questions, realistic range, no contact details needed to see it.
Open the guide price toolOther products for Dolgellau
Like-for-like joinery for Grade I, II* and II properties.
Guide price →Tilt & Turn in DolgellauDual-action hardwood windows for ventilation and cleaning.
Guide price →Replacement in DolgellauFull replacement of failed timber or uPVC windows.
Guide price →Flush Casements in DolgellauSashes that sit flush within the frame for a clean, traditional face.
Guide price →Bay Windows in DolgellauSplayed, square and canted bays built as one structural unit.
Guide price →Double Glazing in DolgellauWarm-edge sealed units in solid hardwood frames.
Guide price →Draught Proofing & Restoration nearby
Questions
How long do hardwood windows actually last?
Properly specified and maintained hardwood joinery has a realistic service life of 60 years or more. The timber is rarely what fails — it is the finish and the seals, and both are renewable. That is the fundamental advantage over uPVC, where a failed unit or a distorted frame means the whole window goes.
Are timber windows warm enough for Building Regulations?
Yes, comfortably. Timber is a natural insulator with far lower conductivity than aluminium or steel. A standard hardwood double-glazed window achieves around 1.2–1.4 W/m²K whole-window, against a 1.4 requirement for replacements. Triple glazing in a deeper section will reach roughly 0.8.
Can I have double glazing in a conservation area?
Usually, yes — using slim-profile sealed units as narrow as 11mm, which fit within traditional glazing bar sections without fattening them. Conservation officers vary, so we specify from the outset to whatever the local authority has stated and provide section drawings for the application.
Do you repair windows or only replace them?
We repair wherever repair is the right answer. Rot is normally localised in a cill or the bottom of a stile, and splicing in new hardwood is typically a third of the cost of replacement. We will tell you honestly at survey which way the economics fall.
Get an indicative price in two minutes
Use the guide price tool for a realistic range, then book a free measured survey in Dolgellau to firm it up. No obligation either way.