Conwy
Hardwood Tilt & Turn Windows in Conwy
Tilt for secure trickle ventilation, turn fully inward for cleaning and escape — the European system in a solid hardwood frame.
Conwy has a housing stock that punishes off-the-shelf joinery — openings settle, reveals go out of square, and cills rarely sit level. Bespoke hardwood tilt & turn windows solve that properly.
Specified for Conwy properties
- Engineered laminated sections on anything over 1.2m, which resist bowing far better than solid stock.
- Stainless or solid brass ironmongery, because plated steel fails first and takes the finish with it.
- Weathered cills with a proper drip groove, so water leaves the timber instead of tracking back under it.
- Glazing beaded internally, so the sealed units can be replaced without disturbing the external finish.
- Trickle ventilation designed into the head where Building Regulations require it, not drilled in afterwards.
We treat hardwood tilt & turn windows in Conwy as joinery rather than a product line. That means real sections, real ironmongery and a finish specified for the exposure the building actually gets.
Ask for the guide price first. If the range works for your budget, we will book a survey in Llandudno and firm it up properly.
Tilt & Turn in Conwy
Free measured survey, fixed written price.
The process
How it runs in Conwy
Get an indicative price
Use the guide price tool or send a photo and rough sizes. You get a realistic range in minutes.
Free measured survey
We measure the openings, record existing profiles and check exposure, access and cill condition.
Fixed quote and drawing
A written price and a section drawing. Nothing is manufactured until you approve it.
Manufacture and install
Made, finished and cured in the workshop, then fitted by our own team with making good included.
Hardwood Tilt & Turn Windows by town
Questions
Are timber windows warm enough for Building Regulations?
Yes, comfortably. Timber is a natural insulator with far lower conductivity than aluminium or steel. A standard hardwood double-glazed window achieves around 1.2–1.4 W/m²K whole-window, against a 1.4 requirement for replacements. Triple glazing in a deeper section will reach roughly 0.8.
Can I have double glazing in a conservation area?
Usually, yes — using slim-profile sealed units as narrow as 11mm, which fit within traditional glazing bar sections without fattening them. Conservation officers vary, so we specify from the outset to whatever the local authority has stated and provide section drawings for the application.
Do you repair windows or only replace them?
We repair wherever repair is the right answer. Rot is normally localised in a cill or the bottom of a stile, and splicing in new hardwood is typically a third of the cost of replacement. We will tell you honestly at survey which way the economics fall.
Can you match existing windows?
Yes. That is most of what we do. We record the existing sections at survey, reproduce the mouldings and sightlines, and match the finish. On listed buildings we will produce like-for-like profile drawings for the consent application.
Are hardwood windows secure?
Yes. Multi-point locking, laminated glass options and key-locking handles are all available, and a solid hardwood frame is considerably harder to attack than a hollow plastic one. We can specify to PAS 24 where a planning condition or insurer requires it.
Get an indicative price in two minutes
Use the guide price tool for a realistic range, then book a free measured survey in Conwy to firm it up. No obligation either way.