Ayrshire
Heritage Slim Double Glazing in Ayrshire
Slim-profile sealed units let you double glaze a period sash or Georgian bar window without fattening the glazing bars.
Our heritage slim double glazing are made from kiln-dried hardwood, machined in the workshop and factory-finished before they ever reach a Ayrshire site. Wet-brushing on site is where timber windows get a bad name.
Specified for Ayrshire properties
- Stainless or solid brass ironmongery, because plated steel fails first and takes the finish with it.
- Weathered cills with a proper drip groove, so water leaves the timber instead of tracking back under it.
- Glazing beaded internally, so the sealed units can be replaced without disturbing the external finish.
- Trickle ventilation designed into the head where Building Regulations require it, not drilled in afterwards.
- Kiln-dried to 12% moisture content before machining, so the sections stay true once they are installed.
Timber moves. The craft in heritage slim double glazing is anticipating exactly how much, in Ayrshire conditions, and detailing the joints and finish so that movement never becomes a problem.
Lead times for Ayr are typically six to ten weeks from approved drawings, depending on timber and finish. Repairs are usually much quicker.
Slim Glazing in Ayrshire
Free measured survey, fixed written price.
The process
How it runs in Ayrshire
Get an indicative price
Use the guide price tool or send a photo and rough sizes. You get a realistic range in minutes.
Free measured survey
We measure the openings, record existing profiles and check exposure, access and cill condition.
Fixed quote and drawing
A written price and a section drawing. Nothing is manufactured until you approve it.
Manufacture and install
Made, finished and cured in the workshop, then fitted by our own team with making good included.
Heritage Slim Double Glazing by town
Questions
How long do hardwood windows actually last?
Properly specified and maintained hardwood joinery has a realistic service life of 60 years or more. The timber is rarely what fails — it is the finish and the seals, and both are renewable. That is the fundamental advantage over uPVC, where a failed unit or a distorted frame means the whole window goes.
Are timber windows warm enough for Building Regulations?
Yes, comfortably. Timber is a natural insulator with far lower conductivity than aluminium or steel. A standard hardwood double-glazed window achieves around 1.2–1.4 W/m²K whole-window, against a 1.4 requirement for replacements. Triple glazing in a deeper section will reach roughly 0.8.
Can I have double glazing in a conservation area?
Usually, yes — using slim-profile sealed units as narrow as 11mm, which fit within traditional glazing bar sections without fattening them. Conservation officers vary, so we specify from the outset to whatever the local authority has stated and provide section drawings for the application.
Do you repair windows or only replace them?
We repair wherever repair is the right answer. Rot is normally localised in a cill or the bottom of a stile, and splicing in new hardwood is typically a third of the cost of replacement. We will tell you honestly at survey which way the economics fall.
Can you match existing windows?
Yes. That is most of what we do. We record the existing sections at survey, reproduce the mouldings and sightlines, and match the finish. On listed buildings we will produce like-for-like profile drawings for the consent application.
Get an indicative price in two minutes
Use the guide price tool for a realistic range, then book a free measured survey in Ayrshire to firm it up. No obligation either way.