Rutland
Timber Sliding Patio Doors in Rutland
Lift-and-slide gear takes the weight off the seals when the door moves, then drops it back down to compress them shut.
Every timber sliding patio doors we make in Rutland starts the same way: a surveyor measures the actual opening, records the existing profiles and checks how the reveal sits. Nothing is ordered from a catalogue.
Specified for Rutland properties
- Kiln-dried to 12% moisture content before machining, so the sections stay true once they are installed.
- Engineered laminated sections on anything over 1.2m, which resist bowing far better than solid stock.
- Stainless or solid brass ironmongery, because plated steel fails first and takes the finish with it.
- Weathered cills with a proper drip groove, so water leaves the timber instead of tracking back under it.
- Glazing beaded internally, so the sealed units can be replaced without disturbing the external finish.
The case for timber sliding patio doors in Rutland is straightforward — hardwood outlasts the alternatives, can be repaired rather than replaced, and holds the character of the building.
If you are working to a planning or listed building condition in Rutland, send us the wording — we will specify to it and provide the drawings you need.
Sliding Doors in Rutland
Free measured survey, fixed written price.
The process
How it runs in Rutland
Get an indicative price
Use the guide price tool or send a photo and rough sizes. You get a realistic range in minutes.
Free measured survey
We measure the openings, record existing profiles and check exposure, access and cill condition.
Fixed quote and drawing
A written price and a section drawing. Nothing is manufactured until you approve it.
Manufacture and install
Made, finished and cured in the workshop, then fitted by our own team with making good included.
Questions
How long do hardwood windows actually last?
Properly specified and maintained hardwood joinery has a realistic service life of 60 years or more. The timber is rarely what fails — it is the finish and the seals, and both are renewable. That is the fundamental advantage over uPVC, where a failed unit or a distorted frame means the whole window goes.
Are timber windows warm enough for Building Regulations?
Yes, comfortably. Timber is a natural insulator with far lower conductivity than aluminium or steel. A standard hardwood double-glazed window achieves around 1.2–1.4 W/m²K whole-window, against a 1.4 requirement for replacements. Triple glazing in a deeper section will reach roughly 0.8.
Can I have double glazing in a conservation area?
Usually, yes — using slim-profile sealed units as narrow as 11mm, which fit within traditional glazing bar sections without fattening them. Conservation officers vary, so we specify from the outset to whatever the local authority has stated and provide section drawings for the application.
Do you repair windows or only replace them?
We repair wherever repair is the right answer. Rot is normally localised in a cill or the bottom of a stile, and splicing in new hardwood is typically a third of the cost of replacement. We will tell you honestly at survey which way the economics fall.
Can you match existing windows?
Yes. That is most of what we do. We record the existing sections at survey, reproduce the mouldings and sightlines, and match the finish. On listed buildings we will produce like-for-like profile drawings for the consent application.
Get an indicative price in two minutes
Use the guide price tool for a realistic range, then book a free measured survey in Rutland to firm it up. No obligation either way.