Bude, Cornwall
Triple Glazed Timber Windows in Bude
Triple glazing in hardwood needs a deeper frame section to carry the weight. Done right it drops whole-window U-values to around 0.8 W/m²K.
Bude has a housing stock that punishes off-the-shelf joinery — openings settle, reveals go out of square, and cills rarely sit level. Bespoke triple glazed timber windows solve that properly.
What is included
- Warm-edge spacer bars as standard, which cut the cold bridge at the glass edge and reduce condensation.
- Compression seals rather than brush pile where the design allows, for a measurably tighter close.
- FSC-certified hardwood with documented chain of custody, available on request for planning submissions.
- Warm-edge spacer bars as standard, which cut the cold bridge at the glass edge and reduce condensation.
If you have been quoted for triple glazing in Bude and the price looked suspiciously round, it was almost certainly a standard size with a filler piece. We do not work that way.
We survey across Cornwall at no charge and with no obligation. You get a fixed written price, a lead time and a drawing before anything is ordered.
Triple Glazing in Bude
Free measured survey, fixed written price.
Indicative price now
Four questions, realistic range, no contact details needed to see it.
Open the guide price toolOther products for Bude
Splayed, square and canted bays built as one structural unit.
Guide price →Double Glazing in BudeWarm-edge sealed units in solid hardwood frames.
Guide price →Sliding Doors in BudeLift-and-slide hardwood patio doors on hardwood tracks.
Guide price →Roof Lanterns in BudeStructural hardwood lanterns and orangery roof glazing.
Guide price →Accoya Windows in BudeModified timber with a 50-year above-ground warranty.
Guide price →Conservation Windows in BudeWindows detailed to satisfy conservation area planning.
Guide price →Questions
Are timber windows warm enough for Building Regulations?
Yes, comfortably. Timber is a natural insulator with far lower conductivity than aluminium or steel. A standard hardwood double-glazed window achieves around 1.2–1.4 W/m²K whole-window, against a 1.4 requirement for replacements. Triple glazing in a deeper section will reach roughly 0.8.
Can I have double glazing in a conservation area?
Usually, yes — using slim-profile sealed units as narrow as 11mm, which fit within traditional glazing bar sections without fattening them. Conservation officers vary, so we specify from the outset to whatever the local authority has stated and provide section drawings for the application.
Do you repair windows or only replace them?
We repair wherever repair is the right answer. Rot is normally localised in a cill or the bottom of a stile, and splicing in new hardwood is typically a third of the cost of replacement. We will tell you honestly at survey which way the economics fall.
Can you match existing windows?
Yes. That is most of what we do. We record the existing sections at survey, reproduce the mouldings and sightlines, and match the finish. On listed buildings we will produce like-for-like profile drawings for the consent application.
Get an indicative price in two minutes
Use the guide price tool for a realistic range, then book a free measured survey in Bude to firm it up. No obligation either way.